New models: more power per kg and per dm³, and better high temperature performance .
 
Note: this is the GX model - for non GX Model click here
 
A MultiPlus, plus ESS (Energy Storage System) functionality
The MultiPlus-II is a multifunctional inverter/charger with all the features of the MultiPlus, plus an external current sensor option which extends the PowerControl and PowerAssist function to 50 A resp. 100 A. The MultiPlus-II is ideally suited for professional marine, yachting, vehicle and land based off -grid applications. It also has built-in anti-islanding functionality . Several system configurations are possible. For more detailed information see the ESS Design and configuration manual.
 
PowerControl and PowerAssist -
Boosting the capacity of the grid or a generator A maximum grid or generator current can be set. The MultiPlus -II will then take account of other AC loads and use whatever is extra for battery charging, thus preventing the generator or grid from being overloaded (PowerControl function). PowerAssist takes the principle of PowerControl to a further dimension. Where peak power is so often required only for a limited period, the MultiPlus-II will compensate insufficient generator, shore or grid power with power from the battery. When the load reduces, the spare power is used to recharge the battery.
 
Solar energy: AC power available even during a grid failure
The MultiPlus-II can be used in off grid as well as grid connected PV and other alternative energy systems. It is compatible with both solar charge controllers and grid -tie inverters.
 
Two AC Outputs
The main output has no break functionality. The MultiPlus -II takes over the supply to the connected loads in the event of a grid failure or when shore/generator power is disconnected. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption. The second output is live only when AC is available on the input of the MultiPlus -II. Loads that should not discharge the battery, like a water heater for example, can be connected to this output. The loads connected the second output are taken into account by the PowerControl and Po werAssist function.
 
Virtually unlimited power thanks to parallel and three phase operation
Up to 6 Multis can operate in parallel to achieve higher power output. In addition to parallel connection, three units of the same model can be configured for three phase output. But that’s not al l: up to 6 sets of three units can be parallel connected .